Air compressor (air compressor) cleaning method


Long-term operation of the air compressor will cause the equipment to be blocked by scale, which will reduce efficiency, increase energy consumption and shorten life. If scale cannot be removed in time, there is a danger of equipment repair, downtime or end of replacement. For a long time, traditional cleaning methods such as mechanical methods (scraping, brushing), high-pressure water, chemical cleaning (pickling), etc., have many problems when cleaning air compressors: they cannot completely remove deposits such as scales and cause corrosion to equipment. The residual acid causes secondary or scale corrosion on the material, which eventually leads to replacement of the equipment. In addition, the cleaning waste liquid is toxic and requires a large amount of money for wastewater treatment. Enterprises can use high-efficiency environmentally friendly cleaning agents to avoid the above situation. They are highly efficient, environmentally friendly, safe and non-corrosive. They not only have good cleaning effect but also no corrosion to equipment, which can guarantee the long-term use of air compressors. Fustek detergent (special addition of wetting agent and penetrating agent can effectively remove the most stubborn scale (calcium carbonate), rust, grease, slime and other sediments produced in water equipment, and will not cause human body damage. Damage does not cause corrosion, pitting, oxidation and other harmful reactions to steel, copper, nickel, titanium, rubber, plastic, fiber, glass, ceramics, etc., which can greatly extend the service life of the equipment.


Case description: Atlas Copco air compressor model is GA315W-8.5, shaft power 315KW, speed 1492 r/min, displacement 864L/S, head temperature before cleaning is about 97 °C, oil temperature is about 86 °C The compressor head temperature exceeds 100 °C equipment alarm, and the equipment jumps over 110 °C. Before the cleaning, the operating temperature is close to the alarm temperature of the equipment, and it is urgent to clean the heat exchange system. The company adopts Fushitek cleaning agent. After four hours of cleaning, the cleaned equipment is immediately operated. After cleaning, the head temperature is about 83 °C, the oil temperature is about 72 °C, and the temperature drop is obvious, which meets the requirements of the enterprise.

Pretective Products

Face Shield

Dunhua Office Equipment Co., Ltd. , https://www.dunhuaparts.com